FIORENTINI S 150 - SWEEPER OPERATION; ENGINE STARTING AND STOPPING

USE AND MAINTENANCE MANUAL
Road Sweeper S150
Page 23 of 54
0
1
2
1.5
4. SWEEPER OPERATION
4.1. ENGINE STARTING AND STOPPING
Climb in the cab and insert the key into the ignition switch, turning it until the panel lights up
(POS 1). [See Picture 1]
Make sure that the lever of the manipulator is in the neutral position ( N ). [See Picture 1]
Turn the switch to position 1.5 to pre-heat the glow plugs [See Picture 1]
Turn the switch to position 2 to start the engine [See Picture 1]
Picture 1
To stop the engine turn the key to position 0 of the switch. [See Picture 1]