EasyManua.ls Logo

Fiori DB 260 - Starting the Engine

Fiori DB 260
226 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
82
4
OPERATION AND USE
id.:
DB 260 REV. 00 01/07/2015
4.3.7 STARTING THE ENGINE ( g. 19)
DANGER:
Before starting the engine, check that there is no one in the vicinity of the vehicle.
Do not operate the vehicle in closed places without ventilation.
- Check that the parking brake (1) is applied.
- Check that the electrical forward/reverse gear selector (2) is in neutral position (otherwise the vehicle will not
start).
- Check that the emergency button at the rear of the vehicle is deactivated and that the hand accelerator (3)
is in rest position.
- Start the engine by turning the ignition key (4).
- When the engine has started, release the key and check that the engine oil pressure, battery low and coolant
temperature warning lights are off.
CAUTION: Do not try to activate the starter motor with the key inserted for more than 20-30 seconds.
If the engine does not start, wait 2 minutes before retrying, allowing the starter motor to
cool down.
When the engine has started, let it run at about 1000 rpm for a few minutes to allow the oil
to warm up and lubricate all the parts; this is essential in cold climates.
19
3
2
4
1

Table of Contents