FireClass FC500 - Programming Screens Overview; Loop Devices Programming

11
Figure 9: Account window
Notes:
 It is not mandatory to fill out the Notes field.
 Do not add any personal data to the Notes field.
Programming screens
The programming screens of the system are the following:
 Loop devices
 Zones
 Panel outputs
 General options
 Communicators
 Clock
 Log
 Utilities
 User mode
See more information on these screens in the following
sections.
Loop devices programming
On the left side of the window, click the panel name to
expand the tree view. Then click on the required loop, 1,
2 or 3. The devices programming window will display. See
Figure 10.
Note: On the right of Loop 1, Loop 2 or Loop 3, the
current number of devices is shown in brackets.
Table 3: Icons in the tool bar
Icon
Description
Add device: Select new devices.
Removes device: Remove the install devices.
Copies device on the clipboard: This allows you
to copy device data to the clipboard for use in
another account.
Pastes clipboard content: This allows you to add
device data previously copied to the clipboard.
Read loop: This allows you to upload the current
loop data from the panel.
Send elements: This allows you to download the
current loop data to the panel.
Device’s details: This opens a new window
where you can see the device status.
Selection: This allows you to select all devices
or invert the current selection.