Press for Pass Code screen:
• Default Pass Code: 1 2 3 4
• Change digit
• Move between digits
• Accept
• An incorrect Pass Code will return the display
to the Pass Code entry screen
• Three incorrect attempts will lock access for
three minutes
5. Enter Pass Code to Access Engineering Menu
6. Find Detectors
60 seconds
• Press to enable ‘Found’ Detectors at any point
during 60s countdown
• Any unused Detector channels are switched off
• Press to re-scan if number is incorrect
This will be the number
of Detectors found
• ‘Find’ is automatically displayed the first time this process is run. ‘Find’ can also be accessed
in the System Controller settings menu. Find must be performed when adding or removing a
detector to an already ‘Found’ system.
7
To Next Page
