Firstech CM600-AS - Troubleshooting; Remote Start Error Codes; Alarm LED Diagnostics

21
Troubleshooting
Remote Start Error Codes
If the remote start fails to start the vehicle, the parking lights will flash three times immediately. Following
those three flashes the parking lights will flash again corresponding to the error table;
Number of
Parking Light
Flashes
Remote Start Error
1
Motor running | or | must program tach
before 1
st
remote start
2
Ignition on | or | foot brake on
5
Foot brake on
6
Hood open
8
Remote start failure
10
System is in Valet Mode
Alarm LED Diagnostics
When the alarm is triggered the LED (if installed) will flash a certain amount of times as shown in the
table below.
Priority
Trigger
LED Flash Diagnostic
1
Door/Hood/Trunk/Ign
Triggered
2 flashes, rest, then repeat
2
2
nd
Shock Triggered
3 flashes, rest, then repeat
3
2
nd
Auxiliary Input
Triggered
4 flashes, rest, then repeat
4
Panic with remote
5 flashes, rest, then repeat