Fischer Panda 8000 NE - Page 50

The Panda Generator
Seite/Page 50 Panda_8000NE-10000NE_PMS_eng.R02 - Kapitel/Chapter 4: The Panda Generator 11.3.11
Fig. 4.3.5-4: Thermo-switch in the generator winding Thermo-switch in the generator
winding
1. Generator winding
2. Thermo-switch
3. Housing
Two thermo-switches inside the windings to protect the gene-
rator winding, which for safety reasons are installed indepen-
dently in parallel.
Fig. 4.3.5-5: Oil Pressure Switch Oil pressure switch
In order to be able to monitor the lubricating oil system, an oil
pressure switch is built into the system. The oil pressure
switch is at the rear of the engine (In front of the electrical
starter).
Fig. 4.3.5-6: . Failure Bypass switch Failure bypass switch
The failure bypass switch offers the possibility of starting the
generator if the electrical control switches off due to overhea-
ting of the cooling system
1
3
2