Fischer Panda xControl Series - Setting the Display to Flash in the Event of a Fault; Setting the Panel Heating; Setting the Display of the Optional Measurement Data

Panda xControl
Page 20 - Chapter 2: Panda xControl 29.9.16
Fig. 2.5.2.8-1: Sub-menu: Aural Alarm"Off" or "On" can be selected by using the "Step-up"/"Step-
down" keys and then confirmed with the "Start/Stop - Enter“
key.
The "Back" item returns you to the Panel sub-menu.
"Cancel" or "Confirm" can be selected by using the "Step-up"/
"Step-down" keys and then confirmed with the "Start/Stop -
Enter“ key.
2.5.2.9 Setting the display to flash in the event of a fault
The menu item is selected by using the "Step-up"/"Step-down" keys confirmed with the "Start/Stop - Enter“ key. The
respective menu item opens.
Fig. 2.5.2.9-1: Sub-menu: Flashing when Faulty"Off" or "Error" or "Warning and Error" can be selected by
using the "Step-up"/"Step-down" keys and then confirmed
with the "Start/Stop - Enter“ key.
The "Back" item returns you to the Panel sub-menu.
"Cancel" or "Confirm" can be selected by using the "Step-up"/
"Step-down" keys and then confirmed with the "Start/Stop -
Enter“ key.
2.5.2.10 Setting the Panel Heating
The menu item is selected by using the "Step-up"/"Step-down" keys confirmed with the "Start/Stop - Enter“ key. The
respective menu item opens.
Fig. 2.5.2.10-1: Sub-menu: Panel Heating"Off" or "On" can be selected by using the "Step-up"/"Step-
down" keys and then confirmed with the "Start/Stop - Enter“
key.
The "Back" item returns you to the Panel sub-menu.
"Cancel" or "Confirm" can be selected by using the "Step-up"/
"Step-down" keys and then confirmed with the "Start/Stop -
Enter“ key.
2.5.2.11 Setting the display of the optional measurement data
The menu item is selected by using the "Step-up"/"Step-down" keys confirmed with the "Start/Stop - Enter“ key. The
respective menu item opens.