Need help?Do you have a question about the FISCHER ISOSCOPE FMP10 and is the answer not in the manual?
General| Application | Non-destructive coating thickness measurement |
|---|---|
| Display | LCD |
| Interface | USB |
| Measuring method | Magnetic induction |
| Power supply | Battery |
| Operating temperature | 0 to 40 °C |
| Measurement Principle | Magnetic induction and eddy current |
| Accuracy | ±(1% of reading + 1 µm) |
| Resolution | 0.1 µm |
| Probe Diameter | Depends on probe used |
| Storage Temperature | -10 to 60 °C |
Steps to establish a new zero point for accurate calibration curves.
Details one-point and two-point calibration methods and required calibration standards.
Detailed procedure for performing corrective calibration using standards.
Setting nominal thickness values for calibration standards during calibration.
Essential guidelines and precautions for accurate coating thickness measurements.
Procedure to access the instrument's service functions menu using identification numbers.
To Next Page
