22
WASH PREPARATION
Wash Boost options
Your CleanSmart™ washer has an extra dispenser located on the right hand side called
the WashBoost dispenser. You can use this dispenser to boost your wash performance in
two ways:
Stain Treatment
The
STAIN TREATMENT option allows you to add a liquid in-wash fabric stain remover to
help combat tough stains. The liquid treatment is released into your wash at just the right
time to work on any stains present. Short soaks are included in the wash to effectively
boost stain removal. For the stain remover to be dispensed correctly, ensure STAIN
TREATMENT
is selected before starting your wash.
Pre treatment products, such as concentrated spray-on fabric stain removers must NOT be
used in the Wash Boost dispenser.
Dual Wash
For extra dirty loads you can perform a
DUAL WASH. Your CleanSmart™ washer will
complete a double wash; the first is an initial wash to loosen soil and get the wash started
using a cool water temperature to ensure any stains are not “set in”. Detergent for this part
of the wash should be placed in the detergent dispenser. The second part is a complete
wash to remove all traces of dirt. The liquid detergent for this part of the wash should be
placed in the Wash Boost dispenser. When you feel your load requires extra washing, ensure
DUAL WASH is selected from the WASHBOOST options.
Use the manufacturer’s recommended dose of detergent in each of the detergent and Wash
Boost dispensers. However, reduce the amount if you have problems with over-sudsing.
The Wash Boost dispenser is NOT designed to dispense bleach into your wash. The bleach
will not be dispensed correctly and may damage your clothing. Only liquid detergent or
liquid in-wash fabric stain remover must be used (ie no powder).
Adding the liquid in-wash fabric stain remover or liquid detergent
Liquid in-wash fabric stain remover, or liquid detergent only, must be used in the Wash
Boost dispenser. Refer to the manufacturer’s instructions on the package for the correct
dosage. Add the liquid in-wash fabric stain remover or liquid detergent to the dispenser
before starting the wash cycle ensuring you do not exceed the ‘Max Level’ shown on
thedispenser.
To Next Page
Loading...
Need help?
General
