42
FAULT CODES
If a continuous series of beeps sounds, all the lights turn off on the control panel and a
number appears on the display, a fault has occurred. The washer automatically enters this
mode when there is a fault. The word FAU LT will be shown in the control panel display
followed by a number (refer to example shown here). To stop the beeps, touch any button
then perform the following steps:
1 Turn your machine off at the wall.
2 Wait for 60 seconds and turn it back on.
3 Check the machine is level, refer to ‘Levelling instructions’.
4 Remove load and retry.
5 Complete a
RINSE and SPIN.
6 If the fault re-occurs repeat Steps 1 & 2.
If the machine still will not work call your Fisher & Paykel Dealer or Fisher & Payel trained
and supported service teachnician to arrange service.
To Next Page
Loading...
