Fisher & Paykel CLEANSMART 7 Series User Manual

41
BEFORE YOU CALL FOR SERVICE
PROBLEM DISPLAYED AS WHAT TO DO
The washer is
out of balance.
Wash load is out of balance. Ensure the washer is stationary.
Manually redistribute the load.
Check the washer is level, refer to ‘Installation instructions -
Levelling instructions’.
The washer has
too many suds.
The washer has a suds build-up (too much detergent may have
been used for the amount of soil in the load). Wait for suds to
dissolve (about 20min). Rinse clothes using a deep rinse.
Check the standpipe height does not exceed 1200mm.
If using the
DUAL WASH option, reduce the amount of detergent
placed in the detergent dispenser.
If the symptom persists, call your Fisher & Paykel dealer or
Authorised Repairer.
The lid can’t
lock or the lid is
open.
Make sure the lid is closed.
Touch
. Refer to ‘Lid lock’.
If the symptom persists call your Fisher & Paykel dealer or
Authorised Repairer.
The washer is
overloaded.
The washer is overloaded and cannot agitate. Ensure the
washer is stationary. Remove items until the remaining ones can
move freely.
Check that the washer is not siphoning, refer to ‘Installation
instructions - Draining’.
The washer has
stopped.
The power was cut to the washer. The washer will restart
automatically. No action is required.
The washer has
stopped.
The or was touched and the washer was inactive for 3
minutes. The washer will automatically drain to a safe level. Touch
any button to stop autodraining then touch
to resume the
wash cycle.

Fisher & Paykel CLEANSMART 7 Series Specifications

General

Brand	Fisher & Paykel
Model	CLEANSMART 7 Series
Category	Washer
Language	English