44
TROUBLESHOOTING
Operating problems
PROBLEM POSSIBLE CAUSES WHAT TO DO
Too much or too little
water when filling
Your washer is designed to
automatically sense load size and
minimise water use, therefore the
water level may look different to
your previous washer.
This is normal.
Wash water
temperature is
not warm
The unique high efficiency wash
system uses two wash phases.
The second phase may be
cooler than the first to minimise
energy use.
This is normal and will not affect
wash performance.
Too many soap suds Incorrect detergent being used. Ensure that you are using a Low Suds or
HE detergent.
Try using a little less detergent, especially if
garments are only lightly soiled.
Your washer is
making noises
Load is out of balance.
Touch
and redistribute the load.
There is a fault indicated by
continuous beeping or a musical
series of beeps.
Refer to ‘Fault codes’.
Small puddle
coming from under
the washer
A dispenser may be blocked. Refer to ‘Caring for your washer’
To Next Page
Loading...
Need help?
General
