18
6.1 WASH WATER TEMPERATURE
The water temperature of each of the wash temperature settings can be changed.
METHOD OF SETTINGS THE WASH TEMPERATURE
1. Select the OPTION ADJUSTMENT MODE by pressing and holding down the
START/PAUSE button, then pressing the POWER button.
2. Use WASH TEMPERATURE buttons and LED’s to select the temperature setting to be
adjusted, ie. Cold, Cold/Warm, Warm, Warm/Hot, or Hot.
3. Use the ADVANCE button and WASH PROGRESS LED’s to increase or decrease the
temperature. Each time the ADVANCE button is pressed, the WASH PROGRESS LED’s
will advance one position to the right. This increases the temperature by approximately 2
o
F
(1
o
C). (See Table 2 for the approximate temperatures for each of the settings).
4. Select the next temperature range to be changed with the WASH TEMPERATURE buttons
and repeat Step 3. Each Temperature range can be adjusted using this method.
5. To return the washer to Normal operation, press the POWER button.
NOTES
1. Do not use the household water faucets or water heater controls to vary the wash temperature.
The automatic water temperature control system will compensate for variations in household
water temperature and pressure. Adjusting the water pressure or the water heater temperature,
WILL NOT alter the wash temperature.
2. If the washer is used in an installation where only a cold water supply is available, then the cold
temperature range must be selected and the “cold water only” setting must be chosen in the
Option Adjustment mode. Refer Table 2. A blanking cap must be fitted to the hot inlet valve.
If the temperature is set at any other level, the washer will expect hot water when filling. As it
will not detect any hot water, it will eventually display the USER FAULT (see USER FAULT)
that there is no hot water.
3. We recommend that the hot water temperature setting on the household water heater does not
exceed 150
o
F (65
o
C) for personal safety and washer reliability.
4. If the temperature of the cold water supply is warmer than the selected temperature, a cold water
user warning will sound because the washer will be unable to control the water temperature to
the required temperature. To correct this re-adjust the cold temperature to cold only setting or a
temperature that is above the cold water supply.
WATER TEMPERATURE SETTINGS
Temperature
Range
15 min
Wash
LED on
12 min
Wash
LED on
9 min
Wash
LED on
6 min
Wash
LED on
3 min
Wash
LED on
Rinse
LED
on
Final
Rinse
LED on
Spin
LED on
Hot 112 114 116 118 120 122 124 126
Warm/Hot 97 99 101 103 105 107 109 111
Warm 87899193959799101
Cold/Warm7779818385878991
Cold *F 54 56 58 60 62 64 66
Table 2. Water Temperature Settings (
o
F) *F = Cold water only
To Next Page
Loading...
