9
5. Place the screened sealing washers (from the
accessory kit) into the straight end of the inlet hoses and
connect to the faucets.
Turn on the water and check the hose connections for
leaks.
6. Move the washer into its final position. We suggest a
minimum clearance of ¾ “ (20mm) either side of the
washer for ease of installation. Make sure there are no
kinks in the hoses.
7. It is IMPORTANT to level the washer. The rubber
inserts (from the accessory kit) must be fitted into
adjustable feet on the base of the washer. Adjust the
levelling feet by unscrew/screwing so that the stainless
steel basket sits in the cover opening slightly forward of
the center.
8. Make sure the washer is firm on all levelling feet.
9. Plug the cord set into the wall socket.
HOT WATER TEMPERATURE
L The hot water should not exceed 150
o
F (65
o
C).
Water at excessively high temperatures will cause
damage to the washer.
L The cold water should not exceed 95
o
F (35
o
C).
DRAINING
L Draining must comply with the local codes.
L In multi-storey apartments or an upper floor, the
washer should be installed on a drained floor.
To Next Page
Loading...
