22
6.3 END OF CYCLE WARNING BEEPS
The washer finishes each cycle by sounding a series of warning beeps. In some circumstances the
user may wish to increase the number of beeps or eliminate them altogether.
METHOD OF ADJUSTING THE NUMBER OF END OF CYCLE WARNING
BEEPS
1. Select the OPTION ADJUSTMENT MODE by pressing and holding down the
START/PAUSE button, then pressing the POWER button.
2. Use the WASH OPTIONS button and LED’s to select the required option. Pressing the
WASH OPTIONS button will cause the LED’s to change.
Time saver LED ON 15 beeps
Soak LED ON 5 beeps – Factory Setting
Water Saver LED ON 0 beeps
3. To return the washer to Normal operation, press the POWER button.
To Next Page
Loading...
