CONVERSION TO LPIPROPANE GAS
Every range is provided with a set of injectors for the various types of gas.
Select the injectors to be replaced according to the "INJECTORS TABLE".
The nozzle diameters, expressed in hundredths of a millimetre, are marked on the
body of each injector.
SETTING THE PRESSURE REGULATOR (fig.2.5)
The pressure regulator is accessible through the storage compartment by opening
the bottom pivoting panel; the pressure regulator is positioned on the rear left side
of the range.
To set the pressure regulator:
1. Unscrew the regulator cover;
2. Unscrew the A component, reverse and screw it according to the LP/PROPANE
regulation.
Pressure
regulator
LP/PROPAN E
REGULATION
NATU RAL GAS
REGULATION
A
component
1
REGULATOR
COVER
2
Fig. 2.5
19
To Next Page
Loading...
