To Next PageTo Next Page
Need help?Do you have a question about the Fisher i2P-100 and is the answer not in the manual?
General| Brand | Fisher |
|---|---|
| Model | i2P-100 |
| Category | Transducer |
| Language | English |
Details CSA hazardous area classifications including intrinsic safety, explosion-proof, and type n.
Specific conditions for using FM approved products with natural gas and potential ignition risks.
Details FM hazardous area classifications including intrinsic safety, explosion-proof, type n, and non-incendive.
ATEX approved units have multiple approvals; only one protection method is allowed upon installation.
Conditions for safe use of intrinsically safe equipment, including nameplate marking and electrical data.
Conditions for safe use of flameproof equipment, including electrical connections and conduit sealing.
Conditions for safe use of Type n equipment, including nameplate marking requirements.
Details standards used for IECEx certification and conditions for Intrinsically Safe, Type n, Flameproof.
Specifies requirements for clean, dry, noncorrosive supply air/gas and the use of filter regulators.
Details remote venting requirements for natural gas in non-hazardous/hazardous confined areas and vent line piping.
Covers disconnecting power for explosion-proof/natural gas, and wiring for intrinsically safe installations.
Details locations of zero/span adjustments and dip switch settings for configuring input/output ranges.
Outlines safety precautions for performing maintenance, including pressure release and lock-out procedures.
Steps to troubleshoot electrical issues, including polarity, signal range, and switch settings.
Steps to troubleshoot pneumatic issues, including supply pressure, filter, and restrictor.
Shows a typical nameplate with CSA and FM approval markings and specifications.
Shows a typical nameplate with ATEX and IECEx approval markings, conditions, and specifications.
