Fitbit Zip Inspire 2 - Change the band; Remove a band; Attach a band

Change the band
Inspire 2 comes with a small band attached and an additional large, bottom band in
the box. Boththe top and bottom bands can be swapped with accessory bands,
sold separately on fitbit.com. For band measurements, see "Band size" on page42.
Most bands for Inspire and Inspire HR don’t fit Inspire 2. Check fitbit.com for certain
bands that are compatible with the Inspire series. The Inspire clip accessory isn't
compatible with Inspire 2.
Remove a band
1. Turn over Inspire 2 and find the quick-release lever.
2. While pressing the quick-release lever inward, gently pull the band away from
the tracker to release it.
3. Repeat on the other side.
Attach a band
1. To attach a band, hold the band and slide the pin (the side opposite the quick-
release lever) into the notch on the tracker.
2. While pressing the quick-release lever inward, slide the other end of the band
into place.
3. When both ends of the pin are inserted, release the quick-release lever.
15