第 六 页 共 六
with care as you take it from the box and place it on your work surface.
Remove the cardboard packing material and take the accessory box from the printer.
Set the accessory box to the side for now.
The build platform should now be visible. It is an aluminium plate covered in a thin
polyamide film. This is the platform that objects will print on. Remember: do not
remove the film.
The next step is to raise the build platform. There are two ways to do this: 1) Turn the
screw which is behind the rotating platform. 2) Grasp the printing platform with one
hand on each side, and raise it slowly. Try to keep it level as you raise it up just shy of
the black nozzle.
Under the build platform you’ll find the filament -- either one or two rolls, depending
on whether your Creator has one or two extruders. It’s easiest to remove the filament
by first removing all of the remaining packing material.
To Next Page
Loading...
