11
1. Tap[Tools], [Filament] to enter the filament interface.
2. Flip the switch after corresponding extruder to
load corresponding extruder.
3. Tap[Begin], the extruder will start heating.
<
Load Unload
Begin
Left Extruder
Right Extruder
Left Extruder
Right Extruder
<
Cancel
Left Extruder is Heating... Right Extruder is Heating...
69℃ / 220℃ 69℃ / 220℃
31% 31%
ToolsPreheatBuild
Setting Status About
Filament Level Home Manual
HOME
<
Load Filament
<
Done
Loading started, push filament vertically
into extruder and press [Done] when you
see filament come out of the extruder
4. Once heated, filament will be drawn through the extruder. Continue extruding until the extruder
provides a steady flow of filament. Tap [Done], go back. Tap leftwards arrow to go back to the
home screen.
Attetion: If extruder can not unload in a long time, please check if you have inserted filament
into the bottom of extruder.
Left Extruder Heated Right Extruder Heated
To Next Page
Loading...
