Flashforge Cura - Configure Printer Settings

2.3 On the Machine Settings window, kindly fill in the Printer spec as suggested in the red. Switch
to Extruder 1 to confirm the extruder setting as suggested in the red. Then click Next to proceed.
Printer Setting
Printhead Setting
X (Width) 230.0
Y (Depth) 150.0
Z (Height) 140.0
Build plate shape: Rectangular
Original at Center √
Hotend bed √
G-code flavor Marlin
X min -20
Y min -10
X max 10
Y max 10
Gantry Height 140.0
Number of Extruders 1
Start G-code：
End G-code：