Flashforge Guider II - Loading; Changing Filament

08
Loading / Changing Filament
HOME
220℃ / 220℃
100%
220℃
Build Preheat Tools
Filament Level Home Manual
Setting Status About
Load Unload
Cancel
Extruder
I’m heating up...
Changing Filament
Do not pull out the filament with force as it will damage the gears. If the melted
filament has cooled down in the extruder, please repeat the steps above.
Build Preheat Tools
Extruder
Start
1. Tap [Tools] and then tap [Filament] and [Load] to load filament.
2. The extruder will automatically heat up. Once heated, filament will be drawn through the
extruder. Continue extruding until the extruder provides a steady flow of filament.
1. Tap [Preheat]--[Start] to the heat up the extruder.
2. Once preheated, hold down the spring presser and pull out the filament.
3. Tap the return button, insert the new filament into the filament intake, tap [Tools]-[Filament]-
[Load]. The filament will be drawn through the extruder once heated. Wait for the extruder to
provide a steady flow of filament.
100℃
Platform