Guider User Guide | www.ff3dp.com
2.1.2 Terms
The glass surface on which the Guider builds an object.
The blue tape that covers Guider’s build plate so that
the object can adhere to the build plate well.
The three dimensional amount of space that an object
will use once it is completed. The largest build volume
of Guider is 140*140*140
Knobs under the build platform that used for adjust the
distance between the nozzle and build plate.
The device that draws the filament from the spool,
melts it and pushes it through a nozzle onto the build
plate.
Also called “print head”, which located at the bottom
of the extruder where heated filament is squeezed out.
To cool the outer assembly of the extruder and gear
motor
An opening located at the top of the extruder .
A plastic piece that guides the filament from the
filament box to the filament intake
A specific box for placing Flashforge filament
To Next Page
Loading...
