Flashforge Guider - Loading Filament

Guider User Guide | www.ff3dp.com
26
(4-3) Insert the power supply into the power input on the back of the Guider and plug
the power cord into an electrical outlet.
(4-4) Press the power switch to launch the device.
4.3 Loading Filament
Next, we will load the Flashforge filament.(Note: Please lower the build plate
to increase the distance between the nozzle and build plate to 50mm at least for
avoiding nozzle jam.)
（
4-5
）
Tap [Tool].
4-6
4-5
4-6
4-4