Guider User Guide | www.ff3dp.com
After generating the Gcode file, you can transfer it to your Guider. You can transfer
the file through USB cable and USB stick.
6.2.1 Print from Computer (USB connection)
①用Connect your Finder with your PC via a USB cable.(Please refer to 5.1.13)
②Turn on your Guider, level the build plate and load the filament.
③ Click [Print], then click [Connect Machine].A dialog box will pop up. Select
[USB] in Connection Mode and select [Flashforge Guider 3D Printer]. Click
[Connect] to start USB connection, and transfer your Gcode file to your Guider.
④When your PC connects with FlashPrint successfully. The status box on the
bottom right displays the real-time nozzle temperature. After finishing preheating,
your Guider starts the print job directly.
To Next Page
Loading...
