Flashforge Guider - Page 59

Guider User Guide | www.ff3dp.com
58
Preview: If you check the [Preview] box, you can preview your model after slicing is
done.
Print When Slice Done: If you print via USB cable, you can check the box, while if
you print via USB, you should not check the box.
Machine Type: Flashforge Guider
Supports: If you print a model with supports, you should click the inverted triangle
and select [Enable].
Raft: You are suggested to select [Enable].
Resolution: You are suggested to select [Standard]
More Options: You are suggested to keep them default.
6-5