Flashforge Guider - Print from USB Flash Disk

Guider User Guide | www.ff3dp.com
62
● After finishing transferring, the printer will heat up automatically. And when
heating finishes, the print will start to build the model.
6.2.2 Print from USB Flash Disk
①Insert your USB flash disk with target .g or .gx file to your Guider. .
②
Turn on the Guider. Make sure the build plate has been leveled and the filament is
loaded.
③Tap [Print] and then tap the SD Card icon in the middle. The file(s) will display on
the screen., Select the file you want to print and tap [Print]. The file will be
transferred the printer.
⑥And the printer will heat up the nozzle automatically and start to print after the
nozzle reaches the aimed temperature.,
Abort：To stop heating and printing. Once you tap [Abort], the process is irreversible.
Pause
：
To suspend the print job, you can tap it again to resume it. It’s usually used
when you want to change the filament halfway.