Flashforge Guider - Page 72

Guider User Guide | www.ff3dp.com
71
Left-click on the model to select it and double-click on the Cut icon to set the cut
plane. The direction and position are available for setting.
E.g：
As for a big model or an irregular model, you need to cut it into several parts so as to
reduce the printing limitation and to better the print quality. Look at the model below:
Picture 7-4 is the preview of the model’s original placement and Picture 7-5 is the
preview of the model with support structure.
7—4
(7-5) Model with support structure