1. Tap [Tools].
3. Tap [Load Left]. 4. Extruder starts to heats.
2. Tap [Filament].
Load Left
Unload Left
Load Right
Unload Right
Cancel
L Extruder 25
℃ / 230℃
16%
Done
L Extruder 230
℃ / 230℃
Loading begins, push filament vertically into
extruder, and press [Done] when you see
filament come out of extruder
100%
Filament Loading
Print
Filament Level Home
Setting Status About
Manual
Preheat
5. Once heated, filament will be drawn through the extruder. Continue extruding until the extruder
provides a steady flow of filament. Tap [Done], go back. Tap return arrow to go back to home
screen.
14
Attetion: If extruder can not unload in a long time, please check if you have inserted filament
into the bottom of extruder.
To Next Page
Loading...
