FlashPoint Zoom Mini - Advanced Flash Sync Modes; Flash Exposure Compensation (FEC); High Speed Sync (HSS)

8
FEC: Flash Exposure Compensation
With FEC function, this ash can adjust from -3 to +3 in 1/3rd stops. It is
useful in situations where minor adjusting of the TTL system is needed
based on the environment.
Setting FEC:
High Speed Sync
High Speed Sync (HSS ash) enables the ash to synchronize with all
camera shutter speeds. This is convenient when you want to use aperture
priority for ll-ash portraits.
Setting the ash to High-speed Sync mode when on camera:
Use the Flash Setting > Flash Light Function Setting on the camera’s
shooting menu to adjust settings of the ash light. For more details,
please refer to camera’s instruction menu.
• With high-speed sync, the faster the shutter speed, the shorter
the eective ash range.
• Multi ash mode cannot be set in high-speed sync mode.
• Over-temperature protection may be activated after 15
consecutive high-speed sync ashes.
• Try to avoid using high-speed sync ash, which will cut short
ash tube’s lifetime.
ZOOM SYNC
SET
SLAVE
MODE ZOOM SYNC SLAVE
SET
MODE ZOOM SYNC
SET
1
2
3
Press the SET Button and the
ash exposure compensation
amount will be highlighted on
the LCD panel.
Turn the Select Dial to set the
amount.
• “0.3”means 1/3 step,
“0.7”means 2/3 step.
• To cancel the ash exposure
compensation, set the amount
to “+0”.
Press < SET > button again to
conrm the setting.
“FP” on the “SYNC”
setting means the
HSS function is
turned on.
Se
tting “Sync cord jack/S1/S2”high-speed sync ash:
Press the <SYNC> button to open the high-speed sync ash and high-
speed icon < > is displayed.