FlashPoint Zoom Mini - Additional Sync and Manual Modes; Second-Curtain Sync; Manual (M) Flash Mode; Optical Slave Modes (S1;S2)

9
M: Manual Flash
The ash output is adjustable from 1/1 full power to 1/128th power
in 1/3rd stop increments. To obtain a correct ash exposure, use a
hand-held ash meter to determine the required ash output.
Flash Output Range
The following table makes it easier to see how the stop changes in terms
of f/stop when you increase or decrease the ash output. For example,
when you decrease the ash output to 1/2, 1/2-0.3, or 1/2-0.7, and then
increase the ash output to more than 1/2, 1/2+0.3, 1/2+0.7, and 1/1 will
be displayed.
Figures displayed when reducing ash output level
In the M mode, high-speed sync and second curtain sync functions
can be achieved.
Optical S1 Secondary Unit Setting
In M manual ash mode, press the <SLAVE> button so that this ash
can function as an optic S1 secondary ash with optic sensor. With this
function, the ash will re synchronously when the main ash res, the
same eect as that by the use of radio triggers.
Optical S2 Secondary Unit Setting
Press the <SLAVE> button so that this ash can also function as an optic
S2 secondary ash with optic sensor in M manual ash mode. This is
useful when cameras have pre-ash function. With this function, the
ash will ignore a single “preash” from the main ash and will only re
in response to the second, actual ash from the main unit.
S1 and S2 optic triggering and o camera high-speed mode
are only available in M manual ash mode.
1
2
Press < MODE > button so that
< M > is displayed.
Turn the Select Dial to choose a
desired ash output amount.
In-high-speed sync mode,
the adjustable ash range is
1/16~1/1.
MODE ZOOM SYNC
SYNC
SET
Second-Curtain Sync
With a slow shutter speed, you can create a light train following the subject.
The ash res right before the shutter closes.
• Setting the Second-Curtain Sync function on the camera menu,
Use the Flash Setting > Flash Light Function Setting on the camera’s
shooting menu to adjust settings of the ash light. More details please refer
to camera’s instruction menu.
When choosing “REAR” on the “SYNC” setting means the second-
curtain sync function is turned on.