NOTE : The cable is factory set, and therefore should need no adjustment
m) Refit the front burner heat shield to the sides of the fire box (2 Screws)
n) Before making the final gas connection, thoroughly purge the gas
supply pipework to remove all foreign matter, otherwise serious
damage may be caused to the gas control valve on the fire.
The other firebox fixing method is as follows :-
In installations where the cable method is not suitable (e.g. loose masonary in rear
of fire opening) the firebox can be secured to the fire surround using four screws
and wall plugs provided. Below (fig.10) is a diagram to indicate the hole centre
positions available on the firebox to facilitate the screw fixing to the fireplace /
surround.
Fig. 10
17
430mm
300mm
133mm
Firebox
Mounting
Flange
420mm
To Next Page
Loading...
