Fleck 5600SE - Control Start-up Procedures; Set Time Of Day; Enter Control Programming Mode

Page 4
Printed in U.S.A.
MODEL 5600SE Upflow
Control Start-up Procedures
Whenever the valve is in Service the current time of day can be set, the control programmed, or an
extra regeneration initiated at any time.
Push either the Up or Down Set Button once to adjust Time Of Day Display by one digit.
Push and hold either Up or Down Set Button to adjust Time Of Day Display by several digits.
1.
Set Time Of Day
1. Push and hold for 5 seconds both the Up and down Set Buttons to enter Programming
Mode.
2. Push the Extra Cycle Button once per display until all have been viewed and this mode is
exited and normal operation is resumed.
2.
Enter Control Programming Mode