Fleck 5600SE - Start An Immediate Extra Cycle; Regeneration Cycle Displays

Page 6
Printed in U.S.A.
MODEL 5600SE Upflow
Control Start-up Procedures (Cont’d.)
When starting an Extra Cycle, you will have one or two options:
1. Press and Release the Extra Cycle Button:
-With
Immediate Regeneration controls the control will go into regeneration cycle immediately.
-With
Delayed Regeneration controls the Service Arrow will begin to flash immediately and a regeneration
will occur at the present regeneration time (i.e. 2:00 a.m.)
2. Press and Hold for 5 seconds the Extra Cycle Button:
- With Delayed Regeneration controls this will force the control to go into regeneration cycle immediately.
The following series of displays appear when the control enters a regeneration cycle:
4.
Start An Immediate Extra Cycle
5.
Regeneration Cycle Displays