Flexim PIOX S705 User Manual

SU_ModbusV2-8, 2015-03-02
SU_ModbusV2-8
Ergänzung zur Bedienungsanleitung - DEUTSCH
Modbus-Server
Supplement to User Manual - ENGLISH
Modbus Server
FLUXUS ADM 5x07 (Sonderausführung)
FLUXUS ADM 7x07, G70x, F705
FLUXUS ADM 8x27, F808, G80x
FLUXUS ADM 8x27P, G80xP
(mit passivem Stromausgang)
PIOX TS37x
PIOX S705

Flexim PIOX S705 Specifications

General

Measuring Range	0.01 to 25 m/s
Accuracy	±0.5% of reading ±0.01 m/s
Temperature Range	-40 to +200 °C
Power Supply	24 VDC or 100-240 VAC
Number of Channels	1 or 2
Protection Class	IP66
Measurement Principle	Ultrasonic
Technology	Clamp-on
Output Signal	4-20 mA, pulse, relay
Fluid Compatibility	Liquids and gases
Enclosure	IP66
Communication	Ethernet
Repeatability	0.15% of reading

Summary

2 Settings in the Transmitter

Input of the HotCode

Procedure for entering the HotCode to configure the transmitter.

Selection of the Mode

Options for transmitter operation via RS485 interface (sender or Modbus slave).

Input of the Transmission Parameters

Configuring baud rate, parity, and stop bits for Modbus communication.

4 Modbus Register Addresses of Selected Physical Quantities

5 Modbus Register Address Ranges of the Measurement Data

6 Request of a Physical Quantity or a Diagnostic Value

Start Address

Assignment of start addresses to different measuring channels for data retrieval.

Offset of the Physical Quantity or Diagnostic Value

Offsets used to calculate Modbus register addresses for physical quantities.

Offset of the Parameter

Offsets for parameters like state, unit, and time used in Modbus register addressing.

7 Request of Multiple Measured Values or Diagnostic Values

Request of Multiple Measured Values

Procedure for requesting multiple scaled measured values from a channel.

Request of the State of Multiple Measured Values

Procedure for requesting the state of multiple measured values from a channel.

Request of Multiple Diagnostic Values

Procedure for requesting multiple diagnostic values from a channel.

Request of the State of Multiple Diagnostic Values

Procedure for requesting the state of multiple diagnostic values from a channel.

B CRT Editor

B.1 Connection of the Serial Interface RS485

B.2 Input of the CRT Entries

B.3 Activation of the CRT Function