FlexRadio Systems FLEX-5000A User Manual

O P E R A T I N G F O R M S C H A P T E R 5
 RX Only: If this box is checked, the radio will not transmit while in this configured band.
 Power: Sets the Drive control on the front console to this value whenever the VFO is within
the configured band.
 Split RF: Check if the transverter you are using for this band uses separate connectors for
transmit and receive RF. In this case connect your transverter to the Back Panel XVTX/COM
port for transmit RF and the XVRX port for the receive RF. Otherwise, connect it to the XVTX/
COM port only.
 Use XVTR PWR for Tune: When you click the TUN button on the Front Console the power will
be set to the value you enter in the Power control on this form (see above). Otherwise, the
Tune Power setting on the Setup Form – Transmit Tab (page 111) will be used.
[The rest of this page has been left blank intentionally]
142  2003-2008 FlexRadio Systems

FlexRadio Systems FLEX-5000A Specifications

General

Brand	FlexRadio Systems
Model	FLEX-5000A
Category	Transceiver
Language	English