2
Clave 23+ Instruction Manual v1.4
Thank you for choosing our steam sterilizer.
Prior to operating this device, please read the instruction manual carefully and follow all
installation instructions.
Regular maintenance:
If this symbol appears on the screen when the device is powered on or if it shows E88
on the sterilization report, please contact your dealer or local service company for a maintenance
service. This device requires regular maintenance. A symbol or error code E88 will be
displayed after 1 year of use or after a certain number of cycles, whichever comes first. This is
programmed into the maintenance screen.
The Clave 23+ is the same as a Clave 23 except it has a built in compressor that speeds up the
drying process. It also has a bacteria filter that requires replacement approximately every 3
months.
Use only distilled water with this device.
Do not re-use the used water from this machine.
Power on the unit with the door open. This will allow the unit to get a initial zero pressure
reading. The machine may not start a cycle and only beep when the start button is pressed if it
has a non-zero pressure reading on powering up.
To Next Page
Loading...