FD200CPU-7 Ver P Troubleshooting
13
Revision B, May 2008
Troubleshooting
CPU Operation
My CPU Does Not Turn On; There is no Beep or Other Indication of Power
Check to ensure that you have the port 4 DB-15 pinned correctly: Pin 1 is
28VDC and pin 2 is Ground. If this does not solve your issue, please contact
Flight Display Systems’ Technical Support.
My CPU Beeps When I Apply Power, But I Don’t See Anything on my
Screen(s)
If you are using VGA, use a standard computer monitor to verify video output
from Port 3. If you can see in image with a standard computer monitor, check
the wiring, connections, and any distribution units (if applicable) between the
CPU and the monitor(s).
If you are using composite video, check the wiring, connections, and any
distribution units (if applicable) between the CPU and the monitor(s). After
checking those, use a standard computer monitor to check video output from
Port 3 (VGA). If you can see an image on VGA, but not on composite,
contact Flight Display Systems for assistance in changing a BIOS setting.
I Receive an Error in the BIOS Screen When I Start the CPU
Please contact Flight Display Systems for assistance in changing a BIOS
setting.
I Receive an Error in Windows
Please contact Flight Display Systems’ Technical Support for a resolution to
your issue. In some cases, this is as simple as a setting change with the
keyboard.
To Next Page
Loading...