FLIR A6700sc

5 –Camera Controller
A6700sc/A6750sc User’s Manual 25
to be part of the state. If a NUC is loaded that has a setting that differs from the camera state, the
state will override the NUC. If the user wants the NUC setting to override the state then “Load NUC
Options” can be set.
The default setting is to “Load Table Only”, in which case only the NUC coefficients are used from a
NUC file. When the user selects “Load Table and the Following Settings”, the user can select which
parameters from the NUC will override the current state. The option will not affect NUCs that are
currently loaded into RAM, only those NUCs that are subsequently loaded from Flash memory.
Unless a new state is saved, these override settings will not be remembered after a power cycle.
Performing a NUC
To build a NUC table using the camera electronics, select the Perform Correction icon to start
the NUC Wizard for the desired preset.
NOTE: Due to differences in camera electronics and FPA timings it is important to perform the NUC
with the camera operating modes configured as it will be used when imaging.
After selecting the Perform Correction a second window comes up to allow the user to select
correction parameters. When all selections have been made, click Next>> to continue.