Need help?Do you have a question about the FLIR PT-606Z HD and is the answer not in the manual?
General| Type | IP security camera |
|---|---|
| PTZ control | Yes |
| Certification | MIL-STD-810F IEC 60068-2-27 FCC Part 15 (Subpart B, class A) CE, WEEE, ONVIF |
| Placement supported | Outdoor |
| Connectivity technology | Wired |
| Wi-Fi | No |
| Ethernet interface type | Fast Ethernet |
| Supported network protocols | IPV4, HTTP, Bonjour, UPnP, DNS, NTP, RTSP, RTCP, RTP, TCP, UDP, ICMP, IGMP, DHCP, ARP, SCP |
| Sustainability certificates | RoHS |
| Ethernet LAN (RJ-45) ports | 1 |
| Form factor | Bullet |
| Mounting type | Ceiling/wall |
| Product color | White |
| International Protection (IP) code | IP66 |
| Pan range | 0 - 360 ° |
| Pan speed | 60 °/sec |
| Tilt angle range | -90 - 90 ° |
| Minimum illumination | 0.01 lx |
| Field of view (FOV) angle | 24 ° |
| Sensor type | CMOS |
| Optical sensor size | 1/2.8 \ |
| Signal-to-Noise Ratio (SNR) | 120 dB |
| Focus | Motorized/Manual |
| Digital zoom | 12 x |
| Optical zoom | 30 x |
| Number of lenses | - |
| Focal length range | 4.3 - 129 mm |
| Maximum aperture number | 4.7 |
| Minimum aperture number | 1.6 |
| Storage temperature (T-T) | -55 - 85 °C |
| Operating temperature (T-T) | -40 - 70 °C |
| Operating relative humidity (H-H) | 0 - 95 % |
| Total megapixels | 0.3072 MP |
| Maximum resolution | 640 x 480 pixels |
| Thermal frame rate (PAL) | 8.3 Hz |
| Thermal frame rate (NTSC) | 30 Hz |
| Video compression formats | H.264, M-JPEG |
| Analog signal format system | NTSC, PAL |
| AC input voltage | 24 V |
| DC output voltage | 24 |
| Power source type | AC, DC |
| Power consumption (max) | 195 W |
Weight and Dimensions| Depth | 348 mm |
|---|---|
| Width | 467 mm |
| Height | 326 mm |
| Weight | 16400 g |
| Package type | Box |
General description of the PT-Series HD camera's capabilities and features.
Covers general installation, components, connection options, and serial communications.
Details site selection, pre-installation testing, and camera mounting procedures.
Explains critical steps for galvanic isolation and earth ground connection for mounting.
Details connecting power, video, Ethernet, serial interfaces, and DIP switch settings.
Lists the technical specifications for the PT-Series HD camera.
Guides on operating the camera as an IP device and performing initial bench tests.
Explains how to log in, use the live video page, and control the camera via web interface.
Covers essential configuration steps for the camera's operation and settings.
Details camera setup, maintenance, network, date/time, security, and server status.
Explains VMS, serial remote setup, video stream config, firmware, and configuration files.
Provides an overview of thermal imaging principles and common troubleshooting tips.
Provides a table for converting serial addresses from decimal to binary.
To Next Page
