FLIR DM166 - Introduction; 3.1 Key Features

FLIR DM166 USER MANUAL Document Identifier: DM166-en-US_AA
7
3. Introduction
Thank you for selecting the FLIR DM166 True RMS Digital MultiMeter with IGM
TM
(Infrared Guided Measurement) Thermal Imaging. The DM166 can measure voltage up
to 600V AC/DC and includes a VFD function (low pass filter). The thermal imager
measures surface temperature, offers adjustable emissivity, and features a laser pointer
and cross hairs for precise targeting. This device is shipped fully tested and calibrated
and, with proper use, will provide years of reliable service.
3.1 Key Features
 6000 count 2.4” digital TFT display, 320x240 pixels.
 IGM
TM
Infrared imager with selectable color palette, laser pointer, cross hairs targeting, and
adjustable emissivity measures surface temperature
 Thermal imager (80x60 pixels) offers a 30:1 distance-to-spot ratio and a 50
o
x 38.6
o
field-of-
view
 DMM measures AC/DC Voltage (V, mV), AC/DC Current (A, mA, µA), Frequency, Resistance,
Continuity, Diode, Capacitance, and Type-K Temperature
 Built-in non-contact voltage detector (NCV)
 Flex Clamp adaptor direct input
 Automatic and Manual ranging
 Input over-voltage warning (OL)
 Input warning when test leads are incorrectly connected to meter
 MIN-MAX-AVG memory
 Relative offset mode
 Variable-frequency drive ‘VFD’ feature (low-pass filter)
 Data (Display) Hold
 Intelligent Auto Power OFF (APO), customizable
 Safety Category Rating: CAT IV-300V, CAT III-600V.
 Equipped with batteries, test leads, pouch, and Quick Start booklet.