66
Resetting to Factory Defaults
9. RESETTING TO FACTORY DEFAULTS
Follow the steps below to revert all settings to factory defaults. The camera
must be connected to power to perform a factory reset.
1.
Loosen the three tamper screws
using the provided allen key. Lift the
dome cover.
2.
Remove camera cover by squeezing
the back and front of the cover (as
indicat
ed by the arrow indicators) at
the same time and lifting it up and
away from the lens.
3.
Press and hold the black reset
button for 5 seconds then release the
button to r
eset the camera to factory
defaults.
4.Re-attach the camera cover, using
the thumb scr
ew as a guide, until it
snaps into place.
To Next Page
Loading...
