FLIR Duo Pro R - Integration Cable

FLIR Duo Pro R User Guide
Duo Pro R User Guide, Rev. 1.0
Information on this page is subject to change without notice
10
3.1.4 Integration Cable
The Integration Cable is for connecting the FLIR Duo Pro R to a MAVLink-compatible autopilot
and/or standard R/C PWM outputs. The MAVLink interface operates at a default data rate of
57.6 kbps. See Table 2 for pin definitions and Section 5.2.2Error! Reference source not found.
for PWM signal profile.
Figure 3. Integration Cable