Duo Pro R User Guide, Rev. 1.0
Information on this page is subject to change without notice
7 Care of FLIR Duo Pro R
• Power the FLIR Duo Pro R with a regulated 5-26 Vdc power source. Using more than 26 Vdc
will damage the camera and void the warranty.
• Do not touch the lens. If the lens gets dirty, a light dusting of air should dislodge any dust
particles. If the lens is still noticeably dirty, use 75% Isopropyl alcohol and lens tissue. Use
light wiping motions, with a fresh section of lens tissue with each swipe so as not to drag
dust or dirt particles back over the lens surface.
• FLIR Duo Pro R cameras have been focused at the factory and optimized for the maximum
UAS range. Opening the camera may compromise the external seal of the camera and factory
focus may be lost.
• FLIR Duo Pro R is neither water nor dust resistant. Care for it as you would any valuable
piece of electronics equipment.
If you have questions about your Duo Pro R camera, contact FLIR Tech
Support at flirsuas-support@flir.com or SBA-Cores@flir.com. In most
cases, questions related to integrating the Duo Pro R into a particular
airframe should be directed toward one of FLIR’s authorized UAS
distributors.
To Next Page
Loading...
