M500 Web Browser Interface
432-0012-01-12 Version 110 33
Maintenance Menus
After making configuration changes, click the
Save button at the bottom of the page. After
saving, it is also necessary to stop and
restart the server. The server has a
configuration that is active and running, and
another configuration that is saved.
The message at the bottom of the page
indicates the saved configuration is different
than the active (running) configuration, and it
is necessary to restart the server.
Restarting the Server
Click on the green light at the lower left next to “Server
Running” to stop the server.
It may take up to 20 seconds for the server to stop,
especially if multiple video streams are open. Be patient.
Once the server is stopped, an information message will
pop up on the screen.
When the server is stopped and the page is refreshed, the
status will show as “Server Stopped.”
Click to restart the server. When the page refreshes, the
status will again show as “Server Running…”. The Start
button will be replaced by a Stop button when the startup
procedure has completed.
Maintenance->Server->Server Status
The page provides an indication of the current
server status (either running or stopped) and
buttons for starting or stopping the server or
for rebooting the system. Scroll down to see
additional status information which may be
useful to FLIR technical support.
Figure 4-3: LAN Settings
Server Status
To Next Page
Loading...
