M500 Web Browser Interface
432-0012-01-12 Version 110 40
Software Update
When software updates become available, use the Software Update field to load the update to the
camera. The update typically comes with a pre-update file (update-prep.sh) and an update file (for
example, marlin-v2.1.1.swu.sh). Contact the FLIR dealer where you purchased the camera for
additional information, or contact FLIR directly.
Maintenance->Files->Firmware
Accessing the JCU II Web Interface
The JCU II communicates through the Ethernet IP protocol just like the M500 camera does.
Changing the IP Address of the JCU II
On the JCU II, the IP address is displayed by pressing the COLOR button and pushing the joystick
forward at the same time. The IP addresses of the JCU II and the camera are displayed for 3
seconds and then the display returns to its state before the IP request was made.
On networks with specific requirements, you may
need to assign the JCU II a static IP address. Do this
using steps similar to the way you changed the
camera IP address:
1. Determine the JCU II IP address by pressing the
COLOR button and pushing the joystick forward
at
the same time. The IP address is s
hown on
the JCU II screen.
2. Type the JCU II IP address into the address bar
of the browser adding /index.html.
for example: http://192.168.250.110/index.html
The JCU II Web page is shown, with a picture of
the JCU II.
3. For Network Addressing, select Static.
4. Enter the new value in the IP field. The Network Mask should fill in automatically
(255.255.255.0).
5. Click Save to save the changes and exit the Web page.
Click to stop server. The server must be stopped
to upload or download any files.
To Next Page
Loading...
