M500 Web Browser Interface
432-0012-01-12 Version 110 34
Maintenance->Server->LAN Settings
The admin and expert log in accounts can
change the IP address of the camera and
other LAN settings. The M500 system is
shipped with DHCP IP addressing enabled.
Some networks may require that a static IP
address is set. The camera IP address, mask,
and gateway is shown in the figure below. A
Static option is selected with an IP address of
192.168.250.116.
Select the Static or DHCP option and enter
the appropriate information for the network,
then scroll down to select the Save button at
the bottom of the page.
Maintenance->Server->Security Options
Use the Security Options page
to
restrict access through the camera
web server to specific IP addresses
and to set or change passwords.
The admin login can change or set
any password. The expert login can
only configure the expert login
password.
As an additional security measure,
limit access to the web browser
interface to specific computers. Simply add a computer’s IP address and click Add. After all the
allowed IP addresses are entered, select the Save button to save the changes.
Note
To maintain security of the system set new
passwords for each of the three login
accounts.
ß user—The user account can only use
the Live Video page and controls.
ß expert—The expert account can use
the Live Video page, the camera
Setup page, the Server pages on the
Maintenance menu, and set
the
password for the expert login.
ß admin—The admin account can use
all pages and set passwords.
A VMS Remote to the camera, ONVIF or Nexus CGI, uses the same password as the web
interface. Refer to VMS Remote, pg. 3-42.
Select login Click Edit
Enter new password
Click Save
Confirm password
To Next Page
Loading...
