M500 Web Browser Interface
432-0012-01-12 Version 110 35
Maintenance->Sensor->Communications->VMS Remote
Enable ONVIF v2.0 Driver
Enable the ONVIF driver to connect the camera to a VMS or a network video recorder.
1. On the Maintenance->Sensor->Communications->VMS Remote page, select INTERFACE 1.
2. Select Yes to enable driver.
3. Scroll down and select Save.
4. Stop and start the server to make the change effective.
Maintenance->Sensor->Devices->Pan & Tilt
Startup Mode
Select an action the camera will perform at startup (power cycle or server reset).
Scroll down
to Save
Select Yes to
enable driver
Stop and start
Select Interface 1
for ONVIF driver
the server
Scroll down
to Save
Select an action
from the menu
Stop and start
the server
To Next Page
Loading...
Need help?
General
