FLIR PT series

427-0075-01-12 Revision 140 October 2019 34
This document does not contain any export-controlled information.
Basic Operation and Configuration
Surveillance > Scan List
Surveillance > Auto Scan
Relative Auto Scan (Surveillance mode) will scan the scene starting with the current position of the
camera. Absolute Auto Scan will scan the scene starting with the zero azimuth position of the
camera. Both can be started and the parameters set in the web page. Absolute Auto Scan can also
be started as an option in the Startup mode when the camera boots. Refer to
.
2.4.3 Maintenance Menu
When a user logs in as , a complete menu is available. The basic camera
configuration steps are accessed through the Maintenance menu, using the Server submenu on
the left side of the page.The LAN Settings, Date and Time, Server Status, and Security Options
selections are described below. Generally with these settings it is necessary to save the changes to
make them effective, but it is not necessary to stop and restart the server.
Click Set
select Preset ID
position camera,
To setup Presets:
then select Start
select width and speed,
To start Auto Scan:
select limits,
select speed,
Set Autoscan parameters:
click Save