5.6Releasingtheunitfromthe
adaptor
Followthestepsbelowtoreleasetheunitfromthe
Mountingadaptor.
1.Inserttheatofasmallatbladescrewdriver,
orsimilartoolintothereleaseholelocatedon
theatedgeofthemountingadaptorandtwist
thescrewdriver90°,sothatthereisasmallgap
betweentheMountingtrimandMountingtray.
Important:T ohelppreventscratchingtheproduct,
coverthetipofyourscrewdriverwithasmallpiece
ofinsulationtape.
2.TwisttheMountingtrimcounter-clockwise
approximately10°andthenliftawayfromthe
unit.
To Next Page
Loading...
General